Suitable applications
Furniture frames, racks, railings, hardware and light tube structures. Consider the family for repeat parts from small tubes where loading access and final-section processing matter.
19–120 mm front-chuck-offset tube laser Ø19–120 / □19–120
The image is for reference. Actual appearance and configuration may vary.
- Source power, kW
- 1.5
- Round tube, mm
- 19–120
- Effective cutting length, mm
- 6100
A compact solution for small round and square tubes. Front-chuck offset helps retain the final section of the workpiece.
The front chuck moves into the working zone to finish cutting while holding the tube with both chucks. An adjustable-focus head and support rollers form a coordinated feed route. Equipment and open-zone protection are recorded for the particular installation.
Purpose and distinguishing features
19–120 mm front-chuck-offset tube laser
Front-chuck offset changes access to the final section of a small tube. This arrangement suits repeat simple profiles, but a short remnant must be verified on the actual part. No confirmed factory code is available, so a similar machine's identifier is not substituted.
Technical specifications
| Source power, kW | Round tube, mm | Square tube, mm | Effective cutting length, mm | Workpiece mass, kg | Maximum chuck rotation, rpm | Rubber roller diameter, mm | Pneumatic chuck size designation |
|---|---|---|---|---|---|---|---|
| 1.5 | 19–120 | 19–120 | 6100 | 80 | 200 | 190 | 120 |
Choosing a configuration
Confirmed values are a 1.5 kW source, round and square tubes of 19–120 mm, 6100 mm cutting length and an 80 kg load. The source gives no separate factory model code, so the title describes type and range rather than inventing a model. Chuck rotation speed does not establish cutting speed for every contour.
Chucks, supports, feeding, fume removal and the protected working area. Assessment needs materials, wall thicknesses, actual sections and drawings. Remnant length and final-cut quality are agreed from a sample part, not a blanket zero-waste claim.
Discuss configuration
Send a drawing or photograph of the part, material, thickness, blank size and required output. This lets us compare configurations against your job, not just their power rating.
Tell us what you would like to clarify. Add drawings, photos or the required configuration reference to your request if available.
Discuss configurationAlso in the catalogue
GKS-6024T2, GKS-6036T2
Two-chuck tube laser
Round and square tube cutting with two-chuck workholding. Two configurations cover different stock sizes and workpiece weights.
- Source power, kW
- 3 / 4 / 6
- Round tube, mm
- 20–350
- Effective cutting length, mm
- 6500
12050T3, 12065T3, 36T3
Three-chuck tube laser
Three travelling chucks for long and heavy tubes. The range covers different sections and loads, from the 36T3 configuration to 12065T3 for workpieces weighing up to 3000 kg.
- Source power, kW
- 3–30
- Round tube, mm
- 30–600
- Workpiece mass, kg
- 1200–3000
12050T4
Heavy-duty four-chuck tube laser
A system for round tube up to 500 mm, square section up to 350 × 350 mm and workpieces up to 2000 kg. Four travelling chucks support long profiles at different processing stages.
- Source power, kW
- 6–20
- Round tube, mm
- 50–500
- Workpiece mass, kg
- 2000